Wire harness shorting wires test.
Disconnect wire harness connector with wire suspected of damage.
Set multimeter select switch to Ohm.
Connect positive (+) multimeter lead to harness connector terminal of suspect wire.
Connect negative (-) multimeter lead to all terminals in harness connector.
If continuity is measured, suspect wire and wire where continuity is measured are
shorting together. Repair wires.
Wire repair. Refer to TM 43-0158 for detailed instructions concerning electrical wiring repairs.
Wire harness repair is limited to splicing and taping of wires at Unit Maintenance. If wire harness
cannot be repaired, notify Direct Support Maintenance.