CARC paint contains isocyanate (HDI), which is highly irritating to skin and respiratory
system. High concentrations of HDI can produce symptoms of itching and reddening of skin,
a burning sensation in throat and nose, and watering of the eyes. In extreme concentrations,
HDI can cause cough, shortness of breath, pain during respiration, increased sputum
production, and chest tightness. The following precautions must be taken whenever using
ALWAYS use air line respirators when using CARC paint, unless air sampling shows
exposure to be below standards. Use chemical cartridge respirator if air sampling is
DO NOT let skin or eyes come in contact with CARC paint. Always wear protective
equipment (gloves, ventilation mask, safety goggles, etc.).
DO NOT use CARC paint without adequate ventilation.
NEVER weld or cut CARC-coated materials.
DO NOT grind or sand painted equipment without high-efficiency air purifying
respirators in use.
BE AWARE of CARC paint exposure symptoms; symptoms can occur a few days after
initial exposure. Seek medical help immediately if symptoms are detected.
(18) Drill one 1/2-in. (13 mm) hole (17) in rear corner of Battery Box (13), approximately 1 1/2-in.
(3.81 cm) from rear of Battery Box and 1 in. (2.54 cm) down from top.
(19) Clean paint from hole (17) in Battery Box (13).
(20) Install Diode Protection Cable (18), washer (19), and nut (20).
(21) Tighten nut (20).
(22) Using black spray paint, paint hole (17) in Battery Box (13).