Ensure 130G Grader is on level ground, all hydraulic implements are lowered to the
ground, transmission control is moved to Neutral, and the lock and emergency brake are
engaged. Failure to comply could result in serious injury to personnel.
Do not work on hydraulic oil while oil is hot. Failure to comply could result in severe
injury to personnel.
Prolonged contact with lubricating oil, MIL-L-2105, may cause a skin rash. Skin and
clothing that come in contact with lubricating oil should be thoroughly washed
immediately. Saturated clothing should be removed immediately. Areas in which
lubricating oil is used should be well ventilated to keep fumes to a minimum.
Hydraulic oil is slippery and can cause falls. To avoid injury, wipe up all spilled hydraulic
oil with rags.
Remove hydraulic fill cap to vent pressure from hydraulic tank.
Use Operator's controls to lower all components and relieve hydraulic system pressure.
Failure to comply may result in serious injury or death to personnel.
Retain all items (except bench stock items) removed from 130G Grader for future use.
Remove hydraulic tank fill cap to vent pressure from hydraulic tank (TM 5-3805-261-10).
Install hydraulic tank fill cap.
Remove two screws (1) and Hydraswivel
plate (2) from Hydraswivel (3).
Install Hydraswivel Gaskets and Hydraswivel
Shims in same manner as removed or damage
to equipment could result.
Remove two Hydraswivel Gaskets (4) and (5)
from Hydraswivel plate (2).
Inspect Hydraswivel Gaskets (4) and (5) and
Hydraswivel Shims (6). If damaged, replace.