A cut depth (or depth of excavation)
is the distance between bench
elevation and target grade line
(solid line) on Graphic Display.
Positive depth cuts are above
reference elevation and negative
depth cuts are below reference
Majority of normal excavating uses
negative depth cuts.
Press MODE button to access MAIN
Point menu arrows to SET CUT DEPTH
mode using Up and Down (↑↓) buttons.
Press ENTER button to confirm selection.
Current CUT DEPTH appears in lower left
corner of screen after "E." An instruction
window SET CUT DEPTH appears in the
center of the screen.
Cut depth value is the vertical
distance from benchmark eleva-
tion to bottom of trench or
To restore default cut depth of
0.00 ft, simultaneously press Up
and Down (↑↓) buttons.
Adjust displayed elevation value to correct
Press ENTER button to confirm selected DEPTH OF
CUT value. Normal Operating Screen returns.