(102) Measure and cut Guide Rod (114) to
3-1/4-inch (8.25 cm) length on short
side and 10-inch (25.4 cm) length on
Properly position Poly Tube and
Poly Tube and Guide Rod Bracket
straight on the Bucket Cylinder or
damage to equipment may result.
Wedges are used under the Poly
Tube clips and hose clamps to
keep the Poly Tube straight.
Guide Rod Bracket is installed as
close as possible to the bottom
edge of the Bucket Cylinder.
When installed properly, with the
Guide Rod Bracket, the Poly Tube
will appear straight in line with
Encoder and offset from
centerline on Bucket Cylinder.
A combination of large and small
wedges are used to level the Poly
Tube to the Bucket Cylinder.
(103) Install Poly Tube (36) on Bucket
Cylinder (115) with five Hose
Clamps (116), two Hose
Clamps (117), four Poly Tube
Clips (118), wedges (119), and Guide
Rod Bracket (120).