Table 3-7. Blade Pro Motor Grader Control System Troubleshooting (Cont)
Test or Inspection
FAULT 3-6. CROSS-SLOPE SIDE DOES NOT CUT DESIRED SLOPE.
The 130G Grader (1) may not be able to cut material at the depth you are trying to cut.
Try making several passes to remove material.
The 130G Grader (1) may need to be calibrated.
Excessive 130G Grader mechanical wear can give the Blade Pro Motor Grader Control
System false sensor readings.
Check 130G Grader (1) for excessive mechanical wear.
Inspect 130G Grader (1) for wear (Section VII).