TM 11-5860-201-20P
INTRODUCTION
1. Scope
Code
Definition
PDSupport item, excluding support equipment,
This manual lists spares and repair parts; special
procured for initial issue or outfitting and
tools; special test, measurement, and diagnostic
stocked only for subsequent or additional
equipment (TMDE), and other special support
initial issues or outfittings. Not subject to
required for performance of
equipment
automatic replenishment.
organizational maintenance of the AN/GVS-5. It
XAItem is not procured or stocked because the
authorizes the requisitioning and issue of spares and
requirements for the item will result in the
repair parts as indicated by the source and main-
replacement of the next higher assembly.
tenance codes.
XDA support item that is not stocked. When
2. General
required, item will be procured through nor-
mal supply channels.
This Repair Parts and Special Tools List is divided
into the following sections:
NOTE
Cannibalization or salvage may be used
and repair parts authorized for use in the per-
as a source of supply for any items source
formance of maintenance. The list also includes
coded above except those coded XA and
parts which must be removed for replacement of the
aircraft support items as restricted by
authorized parts. Parts lists are composed of func-
AR 700-42.
tional groups in numeric sequence, with the parts in
(2) Maintenance code. Maintenance codes are
each group listed in figure and item number sequen-
assigned to indicate the levels of maintenance
ce.
authorized to USE and REPAIR support items. The
b. Section II. Special Tools List. Not applicable.
maintenance codes are entered in the third and
c. Section IV. National Stock Number and Part
fourth positions of the Uniform SMR Code format
Number Index. A list, in National item iden-
as follows:
tification number (NIIN) sequence, of all National
(a) The maintenance code entered in the third
stock numbers (NSN) appearing in the listings,
position will indicate the lowest maintenance level
followed by a list, in alphameric sequence, of all part
authorized to remove, replace, and use the support
numbers appearing in the listings. National stock
item. The maintenance code entered in the third
numbers and part numbers are cross-referenced to
position will indicate one of the following levels of
each illustration figure and item number ap-
maintenance:
pearance.
Code
Application/Explanation
3. Explanation of Columns
OSupport item is removed, replaced, used at the
organizational level.
a. Illustration. This column is divided as follows:
(1) Figure number. Indicates the figure number
(b) The maintenance code entered in the
of the illustration on which the item is shown.
fourth position indicates whether the item is to be
(2) Item number. The number used to identify
repaired and identifies the lowest maintenance level
item called out in the illustration.
with the capability to perform complete repair (i.e. ,
b. Source, Maintenance, and Recoverability
all authorized maintenance functions). This position
(SMR) Codes.
will contain one of the following maintenance codes:
(1) Source code. Source codes indicate the man-
Code
Application/Explanation
ner of acquiring support items for maintenance,
OThe lowest maintenance level capable of com-
repair, or overhaul of end items. Source codes are en-
plete repair of the support item is the
tered in the first and second positions of the
organizational level.
Uniform SMR Code format as follows:
F--The lowest maintenance level capable of com-
Definition
Code
plete repair of the support item is the direct
PA--Item procured and stocked for anticipated or
support level.
known usage.
Previous Page
