TM 11-5860-201-30P
INTRODUCTION
1. Scope
De finition
Code
PAItem procured and stocked for anticipated or
This manual lists spares and repair parts; special
known usage.
tools; special test, measurement, and diagnostic
PBItem procured and stocked for insurance
equipment (TMDE), and other special support
purpose because essentiality dictates that a
equipment required for performance of direct
minimum quantity be available in the
s u p p o r t maintenance of the AN/GVS-5. It
supply system.
authorizes the requisitioning and issue of spares and
PDSupport item, excluding support equipment,
repair parts as indicated by the source and main-
procured for initial issue or outfitting and
tenance codes.
stocked only for subsequent or additional
2. General
initial issues or outfittings. No subject to
automatic replenishment.
This Repair Parts and Special Tools List is divided
PESupport equipment procured and stocked for
into the following sections:
initial issue or outfitting to specified
a. Section II. Repair Parts List. A list of spares
maintenance repair activities.
and repair parts authorized for use in the per-
PGItem procured and stocked to provide for
formance of maintenance. The list also includes
sustained support for the life of the
parts which must be removed for replacement of the
equipment. It is applied to an item peculiar
authorized parts. Parts lists are composed of
to the equipment which, because of probable
functional groups in numeric sequence, with the
discontinuance or shutdown of production
parts in each group listed in figure and item number
facilities, would prove uneconomical to
sequence.
reproduce at a later time.
b. Section III. Special Tools List. A list of special
.
XAItem is not procured or stocked because the
tools, special TMDE, and other special support
requirements for the item will result in the
equipment authorized for the performance of
replacement of the next higher assembly.
maintenance.
XDA support item that is not stocked. When
c. Section IV. National Stock Number and Part
required, item will be procured through
N u m b e r Index. A list, in National item iden-
normal supply channels.
tification number (N I IN) sequence, of all National
NOTE
stock numbers (NSN) appearing in the listings,
Cannibalization or salvage may be used
followed by a list, in alphameric sequence, of all part
as a source of supply for any items source
numbers appearing in the listings. National stock
coded above except those coded XA and
numbers and part numbers are cross-referenced to
aircraft support items as restricted by
each illustration figure and item number ap-
AR 700-42.
pearance.
(2) Maintenance code. Maintenance codes are
3. Explanation of Columns
assigned to indicate the levels of maintenance
a Illustration. This column is divided as follows:
authorized to USE and REPAIR support items. The
(1) Figure number. Indicates the figure number
maintenance codes are entered in the third and
of the illustration on which the item is shown.
fourth positions of the Uniform SMR Code format
(2) Item number. The number used to identify
as follows:
item called out in the illustration.
(a) The maintenance code entered in the third
b. Source, Maintenance, and Recoverability
position will indicate the lowest maintenance level
(SMR) Codes.
authorized to remove, replace, and use the support
(1) Source code. Source codes indicate the
item. The maintenance code entered in the third
manner of acquiring support items for maintenance,
position will indicate one of the following levels of
repair, or overhaul of end items. Source codes are
maintenance:
entered in the first and second positions of the
Uniform SMR Code format as follows:
Previous Page
