TM 11-6625-2684-30P
INTRODUCTION
Definition
Code
1. Scope
PAItem procured and stocked for anticipated or
This manual lists spares and repair parts; special
known usage.
tools: special test, measurement, and diagnostic
XA-Item is not procured or stocked because the re-
equipment (TMDE), and other special support
quirements for the item will result in the
equipment required for performance of direct sup-
replacement of the next higher assembly.
port maintenance of the TS-3620/GVS-5. It author-
XDA support item that is not stocked. When re-
izes the requisitioning and issue of spares and repair
quired, item will be procured through normal
parts as indicated by the source and maintenance
supply channels.
codes.
NOTE
2. General
Cannibalization or salvage maybe used as a
source of supply for any items source coded
This Repair Parts and Special Tools List is divided
above except those coded XA and aircraft
into the following sections:
support items as restricted by AR 700-42.
and repair parts authorized for use in the perform-
(2) Maintenance code. Maintenance codes are
ance of maintenance. The list also includes parts
assigned to indicate the levels of maintenance
which must be removed for replacement of the au-
authorized to USE and REPAIR support items. The
thorized parts. Parts lists are composed of func-
maintenance codes are entered in the third and
tional groups in numeric sequence, with the parts in
fourth positions of the Uniform SMR Code format as
each group listed in figure and item number se-
follows:
quence.
(a) The maintenance code entered in the
b. Section III. Special Tools List. Not applicable.
third position will indicate the lowest maintenance
level authorized to remove, replace, and use the sup-
c. Section IV. National Stock Number and Part
port item. The maintenance code entered in the
Number Index. A list, in National item identifica-
third position will indicate one of the following
tion number (NIIN) sequence, of all National stock
levels of maintenance:
numbers (NSN) appearing in the listings, followed
-
by a list, in alphameric sequence, of all part numbers
Application/Explanation
Code
appearing in the listings. National stock numbers
OSupport item is removed, replaced, used at the
and part numbers are cross-referenced to each illus-
organizational level.
tration figure and item number appearance.
FSupport item is removed, replaced, used at the
direct support level.
3. Explanation of Columns
DSupport items that are removed, replaced, used
at depot, mobile depot, specialized repair ac-
a. Illustration. This column is divided as follows:
.
tivity only.
(1) Figure number. Indicates the figure num-
(b) The maintenance code entered in the
ber of the illustration on which the item is shown.
fourth position indicates whether the item is to be
(2) Item number. The number used to identify
repaired and identifies the lowest maintenance level
item called out in the illustration.
with the capability to perform complete repair (i.e.,
b. Source, Maintenance, and Recoverability
all authorized maintenance functions ). This position
(SMR) Codes.
will contain one of the following maintenance codes:
(1) Source code. Source codes indicate the man-
Code
Application/Explanation
ner of acquiring support items for maintenance, re-
FThe lowest maintenance level capable of com-
pair, or overhaul of end items. Source codes are
plete repair of the support item is the direct
entered in the first and second positions of the
support level.
Uniform SMR Code format as follows:
Previous Page
