TM 5-6675-348-13&P
c.
Sensor calibration must be done when you change cutting edges or tires and/or remove/
install sensors from one grader to another grader.
Sensor calibration should be redone if 130G Grader is not cutting to proper grade.
NOTE
Below is the calibration procedure for
FULL CALIBRATE.
(1)
Set OFF/ON/SET-UP switch (2) to
SET-UP.
Left Display
Right Display
REFERENCE
0.00
(2)
Toggle left Increase/Decrease toggle
switch (3) down until following
appears:
Left Display
Right Display
CALIBRATE
RESET
(3)
Press left RESET button (5) to enter
CALIBRATE.
Left Display
Right Display
FULL
CALIBRATE
3-25
Previous Page
