TM 5-6675-348-13&P
This Task Covers:
a. Arm Sensor.
b. Boom Sensor.
c. Tool Box.
d. Follow-On Maintenance.
INITIAL SETUP
Materials and Parts (Cont.)
Models
Label, Warning, Welding/Jump Starting,
JD 230 LC HYEX
Item 2, Appendix K
Ring, Arm Sensor Mounting, (2), Item 2,
Tools and Special Tools
Tool Kit, Automotive Maintenance, Common
Ring, Boom Sensor Mounting, Item 3,
No. 2, Item 2, Appendix B
Tool Kit, Welders, Item 4, Appendix B
Personnel Required
Materials and Parts
MOS 62B
Gloves, Chemical Oil Protective, Item 4,
MOS 44B
Goggles, Industrial, Item 5, Appendix F
Equipment Condition
Hook, Pile, Item 6, Appendix F
Engine OFF (TM 5-3805-280-10).
Non-Electrical, Safety Wire, Item 7,
Track chocked (TM 5-3805-280-10).
Batteries disconnected (TM 5-3805-280-10).
Paint, Spray, Black, Item 8, Appendix F
Belly Plates removed as required (Para 4-30).
Ties, Cable, Item 15, Appendix F
a.
Arm Sensor.
(1)
Measure and mark two points (1)
18-7/8 in. (47.9 cm) from top of
Arm (2).
(2)
Using a straightedge, draw a line
under Arm Pin (3) using marks made
in Step (1).
(3)
Draw a line 90 degrees to the line
drawn in Step (2), at center of Arm
Pin (3).
Previous Page
