TM 11-5860-200-12
3-16. Removal of Electronics Assembly (fig. 3-14).
WARNING
Do not work on or near forward pylon fairing assembly until helicopter rotor stops turning.
Ensure aircraft battery is disconnected before installing or removing any ALT component.
Death or serious injury could result if aircraft battery remains connected.
a.
Gain access to receiver and electronics assembly (para 3-12).
b.
Disconnect cables connector 16A4P1 from J1 (6).
c.
Remove the holding clamps and hardware (3) from the mount.
d.
Position the electronics assembly (2) so that the ground strap (7) and remaining cables can be disconnected.
e.
Disconnect cable connector 16A4P2 from J2 (5).
f.
Disconnect cable connector 16A4P3 from J3 (4).
g.
Remove ground strap hardware (1) and ground strap (7) from electronics assembly (2).
h.
If the same electronics assembly (2) is to be re-installed, replace ground strap hardware (1) on electronics
assembly (2).
i.
Using the handle on the front panel, lift the electronics assembly (2) from the mounting.
3-22
Previous Page
