TM 11-5860-200-12
3-18. Removal of Control Panel (fig. 3-16).
WARNING
Ensure aircraft battery is disconnected before installing or removing any ALT component. Death
or serious injury could result if aircraft battery remains connected.
NOTE
Cyclic control stick must be in full aft position.
a.
Loosen the four spring-lock fasteners (2) that secure control panel (3) to the pilot's instrument panel (1).
b.
Lift the control panel from the instrument panel.
c.
Disconnect the two electrical connectors from rear of control panel.
d.
Remove control panel.
3-19. Installation of Control Panel (fig. 3-16).
WARNING
Ensure aircraft battery is disconnected before installing or removing any ALT component. Death
or serious injury could result if aircraft battery remains connected.
NOTE
Cyclic control stick must be in full aft position.
a.
Connect the two electrical connectors to the rear of control panel.
b.
Position control panel (3) in the pilot's instrument panel (1).
c.
Secure control panel by tightening the four spring-lock fasteners (2).
3-26
Previous Page
