TM 11-5860-200-12
3-17. Installation of Electronics Assembly (fig. 3-15).
WARNING
Do not work on or near forward pylon fairing assembly until helicopter rotor stops turning.
Ensure aircraft battery is disconnected before installing or removing any ALT component.
Death or serious injury could result if aircraft battery remains connected.
a.
Gain access to receiver and electronics assembly (para 3-12).
b.
Remove electronics assembly (2) from transit case (para 3-6).
c.
Remove two holding clamps and hardware (3) from aircraft.
d.
Place the electronic assembly on the mount in a position that will allow the ground strap (7) and cables to J2
(5) and J3 (4) to be connected.
e.
Connect ground strap (7) to electronics assembly (2) (in 10 o' lock position) using ground strap hardware (1).
c
f.
Connect cable connector 16A4P3 to J3 (4).
g.
Connect cable connector 16A4P2 to J2 (5).
h.
Place the electronics assembly (2) on aircraft mounting so that holding clamps and hardware (3) can be
replaced.
i.
Install the holding clamps and hardware (3).
j.
Connect cable connector 16A4P1 to J1 (6).
k.
Install forward pylon fairing assembly on helicopter (para 3-13).
3-24
Previous Page
