TM 11-6625-2638-30
1-15. Electronic Assembly Cage (Standby) Test Functional Description (fig. 1-7)
a. MODE switch S1 provides the logic commands to the circuit card which then generates simulated servo out-
puts to the electronic assembly to simulate the receiver cage positions.
b. The electronic assembly azimuth and elevation commands and discrete signals to be tested are selected by
DVM/SCOPE switch S3 and are monitored at the ELECT DVM jacks.
c. CAGE lamp DS3 comes on to indicate that the electronic assembly has correctly decoded the simulated
resolver outputs, and that the receiver is in the cage position.
Figure 1-7. Electronic Assembly Cage Test Block Diagram.
1-9
Previous Page
