TM 11-6625-2685-23
CHAPTER 3
DIRECT SUPPORT MAINTENANCE
Section 1. REPAIR PARTS, SPECIAL TOOLS; TEST MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE) AND SUPPORT EQUIPMENT
3-1. Common Tools and Equipment
For authorized common tools and equipment refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
3-2. Special Tools, TMDE, and Support Equipment
Refer to the Organizational and Direct Support Maintenance Repair Parts and Special Tools List (RPSTL),
TM 11-6625-2685-23P. Also refer to the Maintenance Allocation Chart (MAC) in Appendix B.
3-3. Repair Parts
Repair parts are listed and illustrated in the repair parts and special tools list. TM 11-6625-2685-23P covers
organizational and direct support maintenance for this equipment.
Section Il. SERVICE UPON RECEIPT
3-4. Packing/Unpacking
The ALT alignment set does not require any special packing or unpacking procedures.
3-5. Checking Unpacked Equipment
a. Inspect the equipment for damage which occured during shipment. If the equipment has been damaged,
report the damage on SF 364, Report of Discrepancy (ROD).
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions in DA Pam 738-750. The equipment should be placed in service even though a
minor assembly or part that does not affect proper functioning is missing.
c. Check the equipment for modification. Equipment which has been modified will have an MWO number on
the front panel, near the nameplate.
d. Check to see whether all current MWO's have been applied. (Current MWO's applicable to equipment are
listed in DA Pam 310-1 as applicable.)
3-1